Thanks for visiting and hope you find this information helpful. I’ll try to update with more stuff at least once a week. Any questions or if you’re in the UK and need support, you can get in touch via the contact tab at the bottom of this screen.
First Start A CPU
Initialising the CPU
Set Rotary Switch 3 to position 2.
Press reset button on CPU (Off Line Mode no call processing)
Connect your computetr’s serial port to you PBX processor’s RS0 port
Using MATWorX go into MOC mode.
Connect to PBX
Execute Command 00 FD 1 SD CCC .
Red light on CPU flashes fast.
OK appears on the screen.
NOTE: If there are, or likely to be IP stations you need to customise the Switch for this. Virtual PIMs are required for IP stations. (1 Virtual PIM allows 64 IP stations )There is a trade off between IP and TDM stations as seen in the manual. The command 00 can be used to achieve the correct number. see examples shown below.
Execute Command 00 FD 11 SD CCC ( To create 7 virtual and one physical PIMs)
Or Command 00 FD 12 SD CCC ( To create 6 virtual and two physical PIMs )
Or Command 00 FD 13 SD CCC ( To create 5 virtual and 3 physical PIMs )
Or Command 00 FD 14 SD CCC(To create 4 virtual and 4 Physical PIMS.
Set Rotary Switch 3 to position 0.
Press reset button on CPU.



Leave a Comment
You must be logged in to post a comment.